Info Read More
Cabinet Doors

Exactly How to Make Cabinet Doors with Rail as well as Stile…

Exactly How to Make Cabinet Doors with Rail as well as Stile Router Bits|Ability Builder Find out just how to develop cupboard door structures utilizing a rail and also stile router little bit collection. A lot of cupboard doors – specifically if they are made in a manufacturing facility – have structures that are constructed with rail and also stile joints, likewise generally called deal as well as stick joints. Structure cupboard doors is simple when you have a rail as well as stile router little bit established to reduce these joints. Rockler Shaker Rail and also Stile Router Bit Set: Rockler Rail Coping Sled: Sign up for this network for even more of the most up to date woodworking how-to video clips and also brand-new item developments. Click the red subscribe switch at: Locate the most effective woodworking items and also technologies at:

Author Image

19 thoughts on “Exactly How to Make Cabinet Doors with Rail as well as Stile…

  1. I bought these Rockler bits. They are very nice but trying to get the depth to match between the two bits so that the rails and stiles are flush and smooth is very challenging.

    1. If you go back and re-watch the video, pay close attention to the content around the 7:14 time stamp. Here you’ll see the stile/sticking cutter being height adjusted so it’s slot cutter matches the tongue height on a coped piece of the joint. This is the best method to set the second router bit accurately: use a sample coped end to fine-tune the stile cutter’s height. If you do that, the resulting cuts will enable the door frame’s corner joints to fit together accurately and the faces of the rails and stiles will be flush. Of course, make sure the thickness of your rails and stiles matches before you begin the routing process, too.

    2. @Rockler Woodworking and Hardware Thanks for the reply but I’ve watched it several times and I either get a 1/32 layer of wood remaining when I do a test pass or the rails and stiles are not flush by 1/32 to 1/16. I’m tempted to cheat and run the cabinet door thru a planer.

  2. Been using these for years. Any advice on preventing tear out on style bit? Often the decorative profile gets a chewed up look near the groove. White oak and cherry seem to be the worst. I use a slow bit speed and feed slowly.

  3. Where does anyone find panels that are 1/4 inch thick? Most wood today, even plywood is not a true 1/4 inch thick making panels loose.

  4. So that’s what those bits do. I have them sitting in my living room given to me by someone that couldn’t remember what it was, just that it’s very useful. Kind of an idiot if idk what it is and I was gonna sell it online so someone could use them but I didn’t know what it was either and didn’t know how to research two blue and metal heavy things. I just so happened to see it as I’m looking up bevels. Finally 4 years later

    1. Probably not as usually closet doors are made with 1-1/4″ – 1-1/2″ thick material and these are only designed for 3/4″ material.

Leave a Reply

Your email address will not be published. Required fields are marked *